EQT Router User Manual
Revision 1.9.1 Page 59
4. After pressing the Upgrade button, the EQT will be upgraded. Once complete, a message
indicating that the upgrade was successful will appear at the bottom of the screen as shown in
Figure 7-4. Once this message appears, restart the EQT as instructed.
Figure 7-4: EQT Upgrade Screen for Success
7.2. UPGRADING –CS VERSIONS OF THE EQT
The process for upgrading the EQT-3204-3G-CS, EQT-1602-3G-CS and EQT-3224-3G follows the
same steps as above in Section 7.1. The clean switch routers consist of four, three and two individual
components respectively. Each of the devices can be accessed through the Ethernet port on the back
and upgraded individually.
The process for upgrading the router and clean/quiet switch components follows the exact same
process as the above. Upgrading the control panel component can be done using standard ftp
procedures as outlined below.
1. Copy the latest bin file for the control panel to any directory on your computer. (C:\temp)
2. FTP into the control panel using the following command. Replace 192.168.8.9 with the unique
IP of the control panel as shown in Figure 7-5. When prompted for the Login and Password
simply press enter for both.
To Next Page
Loading...
Need help?
General
