evertz EQT-3232-H User Manual

EQT Router User Manual
Revision 1.9.1 Page 61
6. Enter the commands below in the FTP window. If all goes well you will see the file transfer via
Ethernet to the EQT and a Transfer Complete message will display.
type binary
cd /tmp
put C:\temp\LATEST_IMAGE.img
(replace LATEST_IMAGE with the name of the file)
close
quit
7. Without powering down, login to Linux using a Telnet session. Replace 192.168.8.9 with the
unique IP address of your EQT as shown in Figure 7-7.
Figure 7-7: Run Window for Telnet Access
8. At the Linux prompt enter the following commands.
cd /tmp
ls
(this displays the contents on the tmp directory on the EQT. The file sent should display)
upgrade LATEST_IMAGE.img
(replace the LATEST_IMAGE.img with the file you are using)
NOTE: If the upgrade went well a success message will print at the Linux prompt.
9. Power cycle the EQT and verify that the latest code is loaded and booting.

evertz EQT-3232-H Specifications

General

Brand	evertz
Model	EQT-3232-H
Category	Network Router
Language	English