evertz EQT-3232-H User Manual

EQT Router User Manual
Page 36 Revision 1.9.1
Section 6.1.1 describes the method used to setup the EQT for use with Ethernet control panels.
Consult the instruction manual for the respective panels to setup their IP address and configuration.
4.4.2. Controlling the EQT Using Q-Link
The EQT router supports Evertz control panels that have a Q-Link connection. Section 6.1.2 describes
the method used to setup the EQT for use with Q-Link control panels. Consult the instruction manual
for the respective panels to setup their Q-Link address and configuration.
When using Q-Link, it is important to ensure that each device within the Q-Link chain has a unique Q-
Link address.
4.4.3. Controlling the EQT Using Serial
The rear panel of the EQT has one DB9 female serial connector. The EQT supports Quartz (-1)
protocol commands over the serial port (slave end). Any control device that supports Quartz protocol
can control the EQT via the serial port.
For information regarding the Quartz protocol, contact Evertz service. See section 2.4 for a description
of the pin outs.

evertz EQT-3232-H Specifications

General

Brand	evertz
Model	EQT-3232-H
Category	Network Router
Language	English