Evident OmniScan X3 - Basic Operation; Powering On and Off

DMTA-20102-01EN, Rev. 7, October 2022
Basic Operation 41
3. Basic Operation
This chapter describes the basic principles and procedures involved in operating the
OmniScan X3 flaw detector.
3.1 Turning On and Off the OmniScan X3
This section explains how to turn on and off the OmniScan X3 flaw detector. The
OmniScan MXU software shuts down automatically when you turn off the
OmniScan X3 flaw detector.
To turn on the OmniScan X3
1. Press and hold the Power key () for one second.
The system starts up, performs a memory check, and the launch screen appears.
If the system encounters a problem during the start-up phase, the power indicator
light will indicate the nature of the problem using a color code (for details, see “Power
Indicator Light” on page 29).
2. Tap to start the desired application and/or, if applicable, configure connections
such as a removable drive, wireless, or cloud.
To turn off the OmniScan X3
1. Quickly press the Power key ().
NOTE