DMTA-20102-01EN, Rev. 7, October 2022
List of Figures 87
List of Figures
Figure 2-1 Front panel controls of the OmniScan X3 ...................................................... 27
Figure 2-2 Left side panel of the OmniScan X3 ................................................................ 31
Figure 2-3 Push the cover (left) and pull out the hidden USB 2.0 port (right) ............. 32
Figure 2-4 Right side panel of the OmniScan X3 ............................................................. 33
Figure 2-5 Top panel of the OmniScan X3 ........................................................................ 34
Figure 2-6 LEMO and phased array probe connectors ................................................... 35
Figure 2-7 Rear panel of the OmniScan X3 ....................................................................... 36
Figure 2-8 Four anchor points for a harness ..................................................................... 37
Figure 2-9 Removing the compartment door ................................................................... 38
Figure 2-10 Inserting a cable into its port ............................................................................ 38
Figure 2-11 Sliding the door over the aligned cables ........................................................ 39
Figure 2-12 Locking the special-purpose door in place .................................................... 40
Figure 3-1 DC power adaptor plug .................................................................................... 44
Figure 3-2 Battery indicator variations .............................................................................. 46
Figure 3-3 Removing a lithium-ion battery ...................................................................... 47
Figure 4-1 Interior of cooling fan enclosure (cover removed to show cable hole) ...... 55
Figure 4-2 Assembly of fan and cover parts ..................................................................... 56
Figure 4-3 Fan cable disconnection (left) and final placement (right) ........................... 56
Figure 5-1 Acquisition connectors ..................................................................................... 64
Figure 6-1 Scanner encoder LEMO connector (contact view) ........................................ 70
Figure 6-2 Alarm and I/O LEMO connector (contact view) ........................................... 72
Figure 7-1 Ethernet Properties dialog box ........................................................................ 76
Figure 7-2 Jumbo Packet setting ......................................................................................... 77
Figure 7-3 Speed & Duplex setting .................................................................................... 78
Figure 7-4 Configuration in WeldSight ............................................................................. 79
Figure 7-5 Connection status — Ready ............................................................................. 80
Figure 7-6 Connection status — Connected ..................................................................... 81
To Next Page
Loading...