DMTA-20102-01EN, Rev. 7, October 2022
Appendix 84
WELDSIGHTESBT-I Q1480007 WeldSight Inspection software license key (compatible
with FOCUS PX and OmniScan X3 series). Includes data
acquisition and analysis functionalities, and ES BeamTool
license. Comes with two hard USB keys (WeldSight-I and
ES BeamTool). DOES NOT include a dedicated analysis
key. NO replacement keys are available if lost.
OMNI-A-X3-
SPDOOR
Q1000230 OmniScan X3 series special purpose side door upgrade kit
– allows cables to be used when the door is closed.
Includes: (1 ea.) OmniScan X3 series special purpose
protective side door with room for accessories, (1 ea.) USB
3.0, 30 cm (1 ft.) extension, and (1 ea.) printed visual
assembly instructions. NOTE: The special purpose door
offers reasonable protection to objects from entering the
OmniScan X3 but offers only minimal protection to rain or
water. For using the OmniScan X3 into wet or extreme
conditions, Evident recommends using the standard
(sealed) door that is included with each OmniScan X3.
Table 13 Compatible accessories
Accessory
(marketing code)
Part order
number
Description
OMNI-A2-SPLIT128 U8100133 “Y” adaptor (splitter) with OmniScan connectors to
support two phased array probes with a maximum of
64 elements each on a 128 channel OmniScan X3 flaw
detector.
OMNI-A2-SPLIT128-
4UT
U8100134 “Y” adaptor (splitter) with OmniScan connectors to
support two phased array probes with a maximum of
62 elements each and 4 UT channels with LEMO 00
connectors on a 128 channel OmniScan X3 flaw detector.
UT channels are connected to elements: 63, 64, 127, 128
OMNI-A2-ADP03 U8775202 Adaptor to connect PA probe with Hypertronic connector
on an OmniScan X3 flaw detector with OmniScan
connector.
Table 12 Optional Items (sold separately on demand) (continued)
Optional item
(marketing code)
Part order
number
Description
To Next Page
Loading...