DMTA-20102-01EN, Rev. 7, October 2022
Basic Operation 45
3.4.1 Battery Status Indicators
The battery status indicators at the top of the display screen indicate the amount of
power remaining in the batteries:
• The percentage of remaining power is displayed next to the indicators. The
OmniScan X3 flaw detector must be turned on for approximately 15 minutes
before it is able to accurately display this information.
• The bar length in the battery status indicator represents the approximate amount
of power remaining in each battery (for example, 70 % ).
The maximum ambient temperature for OmniScan X3 battery discharging is 45 °C
(the maximum OmniScan X3 operating temperature).
If you attempt to turn on the OmniScan X3 with one or two batteries that are too low
for operation, the power indicator light blinks red rapidly for about three seconds.
Replace the battery or batteries, or plug in the DC power adaptor to operate the
OmniScan X3.
Figure 3-2 on page 46 provides details about the variations of the battery charge
indicator.
To Next Page
Loading...