EasyManua.ls Logo

EVOCA Opera - Page 45

EVOCA Opera
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
39 05 2013 4365 00
monitor slave
With this function it is possible to scroll all the informa-
tion related to a possibly connected slave machine.
By switching on the “slave” machine with the display on
this function, the display will show in sequence the infor-
mation of the slave related to:
- Software version
- Type of slave (XX, 0XX, 9XX)
- Presence of the photocells for dispensing detection
- Number of trays and drawers
- Presence of a device blocking the opening of the col-
lection area
- Temperature detected by the internal probe.
To exit the function it is necessary to switch o the “mas-
ter” machine.
display slave information
With this function it is possible to display the instant tem-
perature of the possibly connected “slave” machine.
da serial numbers
This function makes it possible to vary the eight-digit
numerical code which identies the machine (00000000
as default).
programming of the manager Code
This function makes it possible to vary the six-digit
numerical code which identies the machine groups
manager (000000 as default).
loCation Code
Only in some software versions.
This function makes it possible to vary the eight-digit
numerical code which identies the place where the
machine is located (00000000 as default).
installation date
Use this function to store the current system date as the
installation date.
the date is printed at the time of rolling out
statistiCs.
aspirator management
To set up the operation of the fan wheel intended to aspi-
rate powder and/or vapour residues during the prepara-
tion of instant drinks
- ON suction fan wheel in continuous operation mode
- OFF suction fan wheel only operating during the prepa-
ration of the drink and for the subsequent 30 seconds.
TEST
This group of functions allows you to perform tests on
the main components of the machine.
dispensing tests
With this function it is possible to obtain for each se-
lection, with the door open and without inserting the
amount, the dispensing of:
- complete selection: beverage and accessories (cup,
scoop, sugar)
- only water
- only powder
- without accessories
- only accessories
speCial funCtions
The special functions allow you to:
- Operate the infuser unit
- Release a coffee dose
- Open a solenoid valve for letting the air enter in case
the boiler is emptied for maintenance
- Perform the filling of the hydraulic circuit (installation).

Related product manuals