EWM Tetrix 300 - Loading an Existing JOB from the Free Memory; Resetting an Existing JOB to the Factory Setting (Reset JOB)

Design and function
Organising welding tasks (Mode "JOB Manager")
76
099-000121-EW501
29.06.2015
5.12.3 Loading an existing JOB from the free memory
Operating
element
Action
Result
Display
x x
Select JOB Manager mode
Press until the “VOLT”
signal light is on
2 sec.
Select JOB Manager mode
Select the required JOB number using the rotary
transducer (e.g. 150)
1 x
JOB loaded, machine switches back to Display
mode.
The JOB can be customised as required.
Current value and JOB
number displayed
5.12.4 Resetting an existing JOB to the factory setting (Reset JOB)
Operating
element
Action
Result
Display
x x
Select JOB Manager mode
Press until the “VOLT”
signal light is on
2 sec.
Select JOB Manager mode
2 x
Switch from “Load JOB” to “Reset JOB”
Select the required JOB number using the rotary
transducer (e.g. 150)
1 x
JOB reset to factory settings, machine switches
back to Display mode.
Current value and JOB
number displayed