Excell H3 Series - 1-4 Error Messages

7
EXCELL PRECISION CO., LTD.
0300403
4
ZSME200000051
1-4 Error Messages
⇒ Zero value is too high (OIML or NTEP > 10% full scale)
⇒ Zero value is low (OIML or NTEP < -10% full scale)
⇒ Internal value is more than 700000(use in factory calibration)
⇒ Internal value is lower than 100000(use in factory calibration)
⇒ The weight value is over 9d of the maximum capacity. (d=division)
⇒ Internal value is unstable
Unstable time is over 10 seconds after pressing ZERO or
TARE key