Excelltel MS Series - Called Extension Busy Process; Called Extension no Answer Process; Add Prefix Digits for Intercom CID; Add Digits for Intercom CID

MS Series PABX User Manual
17
Description: In auto-attendant work mode, if the C.O. Line caller doesn't
dial the extension number over 5 seconds, then the C.O. line will be cut off.
This is the default setting.
Format: 1 6 1 #
Description: In auto-attendant work mode, if the C.O. Line caller doesn't
dial the extension number over 5 seconds, then the C.O. line will be
transferred to operator or the Ext.Group.
3.9.3 Called Extension Busy Process
Format: 165#
Description: In auto-attendant work mode, if the C.O. Line caller dial
some extension, but it is busy, then the CO line will be cut off, this is the
default setting.
Format: 1650#
Description: when the called extension is busy, the call will be transferred
to operator.
Format: 1655#
Description: when called ext.busy, send prompt beep tone to the
extension.
Format: 1656#
Description: when the called extension is busy, the call will be transferred
to operator ringing extension.
◆ Above setting is just valid for one section OGM mode.
3.9.4 Called Extension No Answer Process
Format: 166#
Description: when the called extension no answer, the C.O. line will be cut
off; this is the default setting.
Format: 1660#
Description: when the called extension no answer, the call will be
transferred to operator.
Format: 1666#
Description: when the called extension no answer, the call will be
transferred to the operator ringing extension.
◆ Above setting is just valid for one section OGM mode.
3.10 Add Prefix Digits for Intercom CID
3.10.1 Add Digits for Intercom CID
Format: 180 KK #
Description: Add KK in intercom Caller ID number
●Some telephone can not display the caller ID number less than 4
digits, so we need to add some prefix digit.
●Default setting: KK=00 ,CID number will add two digit 00.