● ABCD is the initial digits of the outgoing number for routing to
Special trunk line, ABCD can be 1-4 digits, for example: it can be:
0,52,139,1790…etc.
● Q is the group series number from 01 to 16, Q is 2 digits.
II.3 Operating instruction
◆ Enable/Disable the CO.line
◆ Set trunk lines to Normal trunk line / Special trunk line
◆ Enable Routing function & Setting Auto LCR or Manual LCR mode
◆ In manual LCR mode,set outgoing access-code (K) for special trunk
◆ In Auto LCR mode, set certain number for routing to Special Trunk line
then operating as follow:
In Manual LCR mode
If the extension is in indirect dialing-out mode,
Use the Normal trunk line: Pick up the handset Dialing 9 out
the calling number
Use the Special trunk line: Pick up the handset Dialing K out
the calling number
If the extension is in direct dialing-out mode, Pls note: you must
input* to enter the intercom status
In Auto LCR mode
You can dial out the same as before. If the number you dialed with the
prefix you set, then the system will auto access the special trunk line.
Otherwise the system will access the normal trunk line.
Appendix III Auto Add Prefix number
dialing
Through this function,when extension make an outgoing call, then system
will add prefix number automatically in front of the number dialed.
You can set two groups prefix number, each number correspond to any
C.O. Lines
To Next Page
Loading...