Troubleshooting
Fiber Inspection Scope 97
Restoring Your Unit to Normal Operation
To restore you unit to normal operation:
1. Ensure that your unit is completely off (not in sleep mode). If
necessary, turn off your unit by pressing the on/off button for about
three seconds. A shutdown animation will be displayed on the screen.
2. Connect your unit to a power outlet using the provided USB power
adapter. This will ensure that your unit remains powered on during the
whole recovery operation.
3. Press and hold the trigger.
4. While you keep the trigger down, press the on/off button until the unit
beeps once. Release the on/off button, but not the trigger.
5. Keep the trigger down until the Recovery page is displayed, then
release the trigger.
6. Read the instructions, and if you choose to perform the recovery
operation, tap FACTORY RESET.
To Next Page
Loading...
