EXFO FTB-500 - BIEEE 488.2 and Specific Command Reference; IEEE 488.2 Commands-Quick Reference

FTB-500 341
B IEEE 488.2 and Specific
Command Reference
This chapter presents detailed information about the commands and
queries supplied with your FTB-500.
IEEE 488.2 Commands–Quick Reference
The FTB-500 recognizes the required commands identified in IEEE 488.2.
The table below summarizes these commands. These commands are fully
explained on the following pages.
Command Function
*CLS Clear status command
*ESE Standard event status enable command
*ESE? Standard event status enable query
*ESR? Standard event status register query
*IDN? Identification query
*OPC Operation complete command
*OPC? Operation complete query
*RST Reset command
*SRE Service request enable command
*SRE? Service request enable query
*STB? Read status byte query
*TST? Self-test query
*WAI Wait for pending operations to be completed