EasyManuals Logo

Extreme Networks ExtremeRouting SLX 9640 User Manual

Extreme Networks ExtremeRouting SLX 9640
113 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #65 background imageLoading...
Page #65 background image
Figure 32: Optical transceiver extraction tool
Precautions specific to transceivers and cables
Warning
All fiber-optic interfaces use Class 1 lasers.
Warning
Use only optical transceivers that are qualified by Extreme Networks, Inc. and comply with the
FDA Class 1 radiation performance requirements defined in 21 CFR Subchapter I, and with IEC
60825 and EN60825. Optical products that do not comply with these standards might emit
light that is hazardous to the eyes.
Caution
Do not use the port cover tabs to lift the module. They are not designed to support the weight
of the module, which can fall and be damaged.
Caution
Before plugging a cable into any port, be sure to discharge the voltage stored on the cable by
touching the electrical contacts to ground surface.
Cleaning the fiber-optic connectors
To avoid problems with the connection between the fiber-optic transceiver (SFP+, QSFP, or QSFP28)
and the fiber cable connectors, Extreme strongly recommends cleaning both connectors each time you
disconnect and reconnect them. Dust can accumulate on the connectors and cause problems such as
reducing the optic launch power.
To clean the fiber cable connectors, Extreme recommends using a fiber-optic reel-type cleaner. When
not using an SFP+ or QSFP connector, make sure to keep the protective covering in place.
Managing cables
The minimum radius that a 50 micron cable can be bent under full tensile load is 5.1 cm (2 in.). For a
cable under no tensile load, that minimum is 3.0 cm (1.2 in.). Cables can be organized and managed in a
Transceivers and Cables
Precautions specific to transceivers and cables
ExtremeRouting SLX 9640 Hardware Installation Guide 65

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Extreme Networks ExtremeRouting SLX 9640 and is the answer not in the manual?

Extreme Networks ExtremeRouting SLX 9640 Specifications

General IconGeneral
BrandExtreme Networks
ModelExtremeRouting SLX 9640
CategoryWireless Access Point
LanguageEnglish

Related product manuals