Extron electronics MLC 62 Series - Chapter Three • Software Setup; Installing the Configuration Software; Downloading the Software from the Web; Installing the Software from the Disk

MLC 62 Series • Software Setup
Software Setup
3-2
Installing the Configuration Software
The MLC 62 configuration program is used to configure the
MLC's front panel buttons and rear panel ports. The software
is provided on a disk that is delivered with your MLC 62 unit.
You can also download it free from the Extron Web site.
Downloading the software from the Web
If you do not have the software on disk, download it from the
Extron Web site as follows:
1. Go to www.extron.com, and select the Download tab.
2. On the Download Center screen, click the Control
Software button. A Control Software screen is displayed,
containing a list of control software products.
3. In one of the linked alphabets displayed across the top and
bottom of the screen, click M.
4. On the “M” software products page, scroll to locate
MLC 62, and click the Download link at the far right.
5. On the next screen, fill in the required information.
6. Click the Download MLC62SW1xn.exe button.
7. Follow the instructions on the download screens to
download the software and install it on your computer.
Installing the software from the disk
If you have an Extron disk containing the MLC 62 software,
install it on your computer as follows:
1. Insert the disk into your computer drive. The disk should
start automatically. If it does not, open your Windows
Explorer and double-click LAUNCH.EXE on the disk drive to
start it.
2. On the Extron software disk screen, click the Software
button.
3. On the Control Software screen, scroll to locate the
MLC 62, and click the Install link in the far right column.
4. Follow the instructions on the installation screens to
complete the program installation.