58 | S 30.12CI H User Manual
6.1 Trouble Shooting
If the receiver does not work properly after checking it, please contact the dealer. Don't open the
receiver. It may result in a dangerous electric shock and will invalidate your warranty
Problem Possible Causes What to do
The display on front
panel does not light up.
The main power cable is not
connected.
Check that the main power cable is
plugged in to the wall outlet.
Wrong connection of the audio/video
output of the receiver to TV.
Connect the audio/video output
of the receiver to TV correctly.
TV power off. Turn TV on.
The receiver is standby mode.
Change the mode to the normal
mode.
No picture, no sound.
No or Bad signal message appears. Connect the antenna cable correctly.
No Batteries. Change the batteries (both).
The RCU is incorrectly aimed. Aim the RCU properly to the receiver.
The remote control unit
(RCU) does not working.
The receiver is standby mode.
Change the mode to the normal
mode.
Bad picture or noisy
sound in the TV or radio
mode.
Bad reception of the signal.
Make sure the dish and LNB are clean
and correctly adjusted.
To Next Page
Loading...