MCS-4/92 Digital Brushless AC servo drive system - Ref.0707
DECLARATION OF CONFORMITY
Manufacturer: Fagor Automation, S. Coop.
Bº San Andrés 19, C.P. 20500, Mondragón -Guipúzcoa- (SPAIN)
We hereby declare, under our responsibility that the product:
Fagor AC Brushless Servo Drive System
consisting of the following modules and motors:
Servodrives MCS Series
AC Motors FXM and FKM Series
mentioned on this declaration,
with the basic requirements of the European Directives 73/23/CE on Low Voltage
(Basic Safety Regulation; Electrical Equipment on Machines EN60204-1:95) and
92/31/CEon Electromagnetic Compatibility (EN 61800-3:1996, Specific Regulation
on Electromagnetic Compatibility for Servo Drive systems).
In Mondragón, February 28th, 2006.
INTRODUCTION
Fagor offers you a wide range of servo drive systems (AC Brushless motor and
Digital Drive) for applications requiring between 1.2 and 33.6 Nm at speeds between
1200 rev/min and 4000 rev/min for FXM motors and between 1.7 and 16.5 Nm at
speeds between 2000 rev/min and 6000 rev/min for FKM motors.
This manual describes the elements in detail and guides step by step through the
installation and setup of the drive system.
When installed for the first time, it is a good idea to read the whole document.
Should you have any doubts or questions, please do not hesitate to contact our
technicians at any of our subsidiaries worldwide.
Thank you for choosing Fagor.
To Next Page
Loading...
Need help?
General
