MCS- 40/92 Digital Brushless AC servo drive system - Ref.0707
With motor feedback E1 or E3, the output of the encoder simulator multiplies by 4 the
number of pulses of the encoder (1024 x 4 = 4096 ppt). This (4096) is the highest value
to be set in EP1. Note that it may be programmed (it is not a fixed value).
Cabling
Fagor provides these full connections (cables+connectors): SEC, SEC-HD, IECD,
EEC and EEC-SP.
Encoder simulator connecting cable, SEC
Depending on motor feedback, the drive can generate a set of signals that simulate
those of a TTL encoder attached to the rotor of the motor. The SEC cable transfers
these signals from the drive to the 8055 CNC.
Encoder simulator connecting cable, SEC-HD
Depending on motor feedback, the drive can generate a set of signals that simulate
those of a TTL encoder attached to the rotor of the motor. The SEC-HD cable
transfers these signals from the drive to the 8055i CNC or 8040 CNC.
Yellow
Purple
Blue
Grey
Green
Brown
Pink
Black
White
Ready Made Cable Fagor
SEC 1/3/5/10/15/20/25/30/35
(Length in meters; including connectors)
6
5
4
3
2
1
7
8
Cable 4x2x0.14 + 2x0.5
11
Pin
Twisted pair. Overall shield.
Metallic shield connected to CHASSIS pin
(at the 8055 CNC end and at the Drive end)
8
1
15
9
(Sub-D, M15)
Front View
6
5
4
3
2
1
7
8
11
Pin
*Z
Z
*B
B
*A
A
0 volt
Signal
CHASSIS
TO 8055 CNC
1
5
(HD,Sub-D,F15)
Front View
11
15
TO DRIVE
(Sub-D, M15)
(HD,Sub-D,F15)
Yellow
Purple
Blue
Grey
Green
Brown
Pink
Black
White
Ready Made Cable Fagor
SEC-HD 1/3/5/10/15/20/25/30/35
(Length in meters; including connectors)
6
5
4
3
2
1
7
8
Cable 4x2x0.14+2x0.5
11
Pin
Twisted pair. Overall shield.
Metallic shield connected to CHASSIS pin
(at the CNC end and at the Drive end)
6
5
4
3
2
1
7
8
11
Pin
*Z
Z
*B
B
*A
A
0 volt
Signal
CHASSIS
15
11
(HD, Sub-D,
F15)
Front View
5
1
TO DRIVE
1
5
(HD, Sub-D,
M15)
Front View
15
11
TO 8040 CNC
TO 8055i CNC
(HD,Sub-D, F15)
(HD,Sub-D, M15)
To Next Page
Loading...
Need help?
General
