MPC-6000 / MPC-7000 / RND-2 PROGRAMMING MANUAL
17
Maintenance Level
Following are the details of the Maintenance level functions.
Enabling/Disabling Devices
The disable / enable screens allow the operator to disable or enable devices and
components of the system. System Inputs, Outputs, etc., can be disabled / enabled.
NOTE: When a device is already enabled, the disable option is displayed.
Action Result
1. Press “Disable/Enable”.
2. Press “Inputs”.
3. Press “Devices”. The display will show a screen for the address
of the device.
4. Enter the address through the keypad. When the address is entered, the status of the
device will be displayed.
5. Use the “Disable(Enable)” button to change the
state of the device.
Status will toggle on the display.
Enabling/Disabling Input Groups
The input group may be disabled/enabled as follows:
Action Result
1. Press “Disable/Enable”.
2. Press “Inputs”.
3. Press “Groups”. The display will show a screen for the address
of the group.
4. Enter the address through the keypad. When the address is entered, the status of the
group will be displayed.
5. Use the “Disable(Enable)” button to change the
state of the group.
Status will toggle on the display.
Enabling/Disabling Applications
The applications in the FireSmart detector that prevent false activation often make it
difficult to test the detectors using canned smoke. This function allows the Applications
in the detectors to be turned off for testing. A trouble is posted as a reminder to reset
them later.
Action Result
1. Press “Disable/Enable”.
2. Press “Appl”. The display will show the current status of the
applications.
3. Use the “Disable(Enable)” button to change the
status of the applications in the
FireSmart detectors.
Status will toggle on the display.
To Next Page
Loading...
