MPC-6000 / MPC-7000 / RND-2 PROGRAMMING MANUAL
18
Enabling/Disabling PAS*
PAS (Positive Alarm Sequence) may be disabled/enabled as follows:
Action Result
1. Press “Disable/Enable”.
2. Press “More”.
3. Press “PAS”.
The display will show the current status of PAS.
4. Use the “Disable(Enable)” button to change the
state of PAS
.
Status will toggle on the display.
*Refer to page 30 for information on PAS.
Enabling/Disabling the Output Zones
The output zones may be disabled/enabled as follows:
Action Result
1. Press “Disable/Enable”.
2. Press “Outputs”.
3. Press “Zones”. The display will show a screen for the address
of the zone.
4. Enter the address through the keypad. When the address is entered, the status of the
zone will be displayed.
5. Use the “Disable(Enable)” button to change the
state of the zone.
Status will toggle on the display.
Enabling/Disabling NACs
The Notification Appliance Circuits may be disabled/enabled as follows:
Action Result
1. Press “Disable/Enable”.
2. Press “Outputs”.
3. Press “NACs”. The display will show a screen for the number
of the NAC.
4. Enter the number through the keypad and press
“Enter”.
When the address is entered, the display will
show the current state of the NAC.
5. Use the “Disable(Enable)” button to change the
state of the NAC.
Status will toggle on the display.
Enabling/Disabling City Tie
The City Tie Circuit may be disabled/enabled as follows:
Action Result
1. Press “Disable/Enable”.
2. Press “Outputs”.
3. Press “More”.
4. Press “City Tie”. The display will show the status of the City Tie.
5. Use the “Disable(Enable)” button to change the
state of the City Tie.
Status will toggle on the display.
To Next Page
Loading...
