Faraday MPC-6000 - Regulatory Standards (FCC, UL)

MPC-6000 / MPC-7000 / RND-2 PROGRAMMING MANUAL
19
Enabling/Disabling the DACT
The DACT (Digital Alarm Communication Transmitter) may be disabled/enabled as
follows:
Action Result
1. Press “Disable/Enable”.
2. Press “Outputs”.
3. Press “More”.
4. Press “DACT”. The display will show the status of the DACT.
5. Use the “Disable(Enable)” button to change the
state of the DACT.
Status will toggle on the display.
Enabling/Disabling the Status Relays
The Status Relays may be disabled/enabled as follows:
Action Result
1. Press “Disable/Enable”.
2. Press “Outputs”.
3. Press “More”.
4. Press “More”.
5. Press “Status Relays”.
6. Use the keypad to enter the address. The display will show the state of the Status
Relays.
7. Use the “Disable(Enable)” button to change the
state of the Status Relays.
Status will toggle on the display.
Enabling/Disabling the Open Collector Circuits
The Open Collector Circuits may be disabled/enabled as follows:
Action Result
1. Press “Disable/Enable”.
2. Press “Outputs”.
3. Press “More”.
4. Press “More”.
5. Press “OC Ckts”.
6. Use the keypad to enter the address (01-04) and
press “Enter”.
The display will show the state of the OC
Circuit.
7. Use the “Disable(Enable)” button to change the
state of the OC Circuit.
Status will toggle on the display.