MPC-6000 / MPC-7000 / RND-2 PROGRAMMING MANUAL
1
Introduction
The MPC-6000/7000/RND-2 Fire Alarm Control Panels are completely field
programmable. Although programming requires no special software skills, a thorough
working knowledge of Fire Alarm Control Panels and devices is assumed. There are two
ways to program an MPC-6000/7000/RND-2 fire alarm system control unit from the front
panel keypad:
1. Auto Program. Using Auto Program will quickly configure the FACP in a General
Alarm configuration.
2. Manual Program. Editing the program manually using the keypad.
Both methods require that the Technician password be entered so that the Technician
functions may be accessed. Jump to the Quick Start section if you need to get a system
up and running quickly.
Note: All references to the Releasing Application programming options are available on
the MPC-6000 panel only.
The Access levels
The MPC-6000/7000/RND-2 system has three functional levels as follows:
•
User Level, no password is required to access these functions.
•
Maintenance Level, accessed using the Maintenance password, allows access to the
maintenance menu functions.
•
Technician Level, accessed using the Technician password, allows access to trained
technician menu functions.
User Level
The User Level functions accessible to the system user are protected from unauthorized
use by the lock on the front of the cabinet. Pressing the Menu button on the lower right
of the operator interface accesses the user functions. The functions available to the
User are as follows:
•
Activate a General Alarm
•
Activate an Alert event
•
Activate a Recall event
•
Activate a Lamp Test
•
Activate a Drill
•
View event history
•
Go to Maintenance Level (with the password)
•
Go to Technician Level (with the password)
To Next Page
Loading...
