Faraday MPC-6000 - General Specifications; Environmental, Power, and Outputs

MPC-6000 / MPC-7000 / RND-2 PROGRAMMING MANUAL
20
Enabling/Disabling the Releasing Circuits
The Releasing Circuits may be disabled/enabled as follows:
Action Result
1. Press “Disable/Enable”.
2. Press “Outputs”.
3. Press “More”.
4. Press “More”.
5. Press “Rel Ckts”.
6. Use the keypad to enter the address (01-02) and
press “Enter”.
The display will show the state of the Releasing
Circuit.
7. Use the “Disable(Enable)” button to change the
state of the Releasing Circuit.
Status will toggle on the display.
Changing the Maintenance Password
The password for access to the Maintenance level menus may be changed as follows
from the Maintenance starting screen:
Action Result
1. Press “More”.
2. Press “More”.
3. Press “More”.
4. Press “Change Password”. The display will show “change maintenance
password”.
5. Use the keypad to change the password and
press “Enter”.
Setting the Time*
The time and the time format are adjustable.
Action Result
1. Press “More”.
2. Press “More”.
3. Press “More”.
4. Press “Time/Date”.
5. Press “Time”.
6. Press “Set Time”. The display will show the time with the cursor
under the hours.
7. Use the keypad to enter new time. Pressing “Clr”
will clear the entry. Pressing “Set” will set the time.
*The time for a networked system can be set from any point in the system. It can take up to one
minute before all of the points on the system are in sync.