MPC-6000 / MPC-7000 / RND-2 PROGRAMMING MANUAL
38
Enabling the Network Connection to the Panel
This setting is used when the control panel is to be connected to a network. The
networking communications in the panel must be enabled as follows:
Action Result
1. Select “Edit”.
2. Select “Manual Pgm”.
3. Press “Cmor” twice to select “Network Setup”.
4. Select “1” to install the network or “0” to remove
the network setting.
When “1” is selected, Dnxt appears so other
network settings can be made.
Setting the Node Number
If the panel is networked, it must have its network node number set as follows:
Action Result
1. Select “Edit”.
2. Select “Manual Pgm”.
3. Press “Cmor” twice to select “Network Setup”.
4. Select “Dnxt”. Type in the Node number. Be certain to enter leading zeros for nodes 1-9.
A maximum of 99 nodes can be entered.
5. Select “Dnxt” to continue to next setting or
“Bsav” to save the setting.
When “Dnxt” is selected, the screen for the
printer setting displays. When “Bsav” is
selected, the Network Connection screen
displays.
Setting the Printer*
If the printing of events from this node printer is required on the network, then it must be
set as follows:
Action Result
1. Select “Edit”.
2. Select “Manual Pgm”.
3. Press “Cmor” twice to select “Network Setup”.
4. Select “Dnxt”.
5. Select “Dnxt”.
6. To Print Events for the node, select “1” for yes or
“0” for no.
7. Select “Dnxt” to continue to next setting or
“Bsav” to save the setting.
When “Dnxt” is selected, the screen for the
Total Number of Nodes displays. When “Bsav”
is selected, the Network Connection screen
displays.
*For an MPC-6000 / MPC-7000, the default setting for the printer is OFF (Diagnostics test only).
For an RND-2, the default setting for the printer is ON.
To Next Page
Loading...
