MPC-6000 / MPC-7000 / RND-2 PROGRAMMING MANUAL
24
Configuring NAC sound time for Quick Test
The period of time that the NACs will be active after each event in Quick Test is set as
follows:
Action Result
1. Press “Quick Test”.
2. Press “Configure”.
3. Press “NAC time”. The display will indicate the time in seconds
that the NACs will sound during Quick Test.
4. Use the “Inc” and “Dec” buttons to set the time
either to “off” or from 1 to 30 seconds.
Configuring the printer during Quick Test (For Diagnostics Test Only)
Printing may be enabled or disabled during Quick Test as follows:
Action Result
1. Press “Quick Test”.
2. Press “Configure”.
3. Press “Printer”. The display will indicate whether the printer is
enabled or disabled during Quick Test.
4. Use the “Disable(Enable)” button to change
state.
The display will toggle to indicate the state.
Programming a Device
It is possible to program a device address without the programming tool. Following is
the procedure that is used when adding a single new device to the loop.
Action Result
1. Press “More”.
2. Press “More”.
3. Press “Program device”. The panel will display a message as it is
looking for the new device. When a new device
has been found, the display will show a screen
to enter a device address.
4. Use the keypad and “Program” buttons to enter
the address and program the new device. Pressing
“Clr” will clear the entry.
To Next Page
Loading...
