Farfisa PROJECT Series - Si 312 T;1

184
(MT12 - Gb2004)
Si 312T/1
I
NTERCOMS *
VIDEO INTERCOMS *
TELECOMMUNICATION
coax
TWO-WAY VIDEO INTERCOM-TELEPHONE INTERCOMMUNICATING SYSTEM WITH PABX CONNECTED TO ONE EXTERNAL
DOOR STATION
Q.ty Article Description
4 ST 7100W Studio series monitor
4 WB7100 Bracket for monitor
8 ST740W Studio series telephone
8 WB700 Bracket for telephone
1 FT208P PABX
1 ES60-ES65 Intercom-telephone interface for PABX
1 DV2 Video distributor
1 1281 Power supply
1 1382 Timer
1 PA ** Door release push-button (optional)
1 SE ** Electric door lock (12VAC-1A)
Door station series Mody
1 MD72 Module frames with back box
1 MD12 Module for electric door speaker
1 MD82 Hood cover
1 MD92* Rain shelter with module frames
1 MD30 Electric door speaker (amplifier)
1 MD41 Camera
Door station series Matrix
1 MA42 Camera module with integrated audio amplifier
1 MA22 Button modules
1 MA62 Front frame
1 MA72 Back box and module frames
* Rain shelter is use instead of back box and hood cover.
** Articles not supplied by ACI Farfisa.
Notes
- If the maximum number of extensions is 5,
you can use the PABX FT105P.
- For the connection of name plate lamps read
notes 6, 7 and 8 of the installation instructions
on page 91.
- If the control switching ON is necessary, con-
nect terminal 4 of the timer (dashed wire).
- For wires dimensioning and video connec-
tion refer to the installation instructions and
table on pages 91÷93.
Programming
When using the PABX, the following program-
ming must be absolutely carried out:
- intercom interface activation
- activation to receive intercom calls
- how to assign incoming external lines
- how to assign outgoing external lines
See pages 167 and 168.
Application diagram
When using MD200 amplified external door stations, place this diagram on the diagram on page
185 and line it up with the riser.
Cut the resistance R8 on the
bracket of monitors VC1 and
leave it on the bracket of
monitors VC2.
WB7100