Festo 03 - VALVE TERMINAL CONFIGURATION and ADDRESSING General

Contents
4.1 VALVE TERMINAL CONFIGURATION
AND ADDRESSING 4-3
General 4-3
Switching on the operating voltages 4-4
Remote bus 4-5
Installation remote bus 4-5
Calculating the configuration data 4-6
Calculating the number of
inputs/outputs 4-7
Address assignment of valve terminal 4-10
Basic rule 1 4-10
Basic rule 2 4-13
Basic rule 3 4-13
Address assignment after
extension/conversion 4-14
4.2 INTERBUS – BUS CONFIGURATION
AND ADDRESSING 4-16
4.2.1 Bus configuration via the
CMD software 4-16
Inserting with the Ident-code 4-17
Insert slave description 4-20
4.2.2 Bus configuration without
CMD software 4-24
Logical addressing 4-24
Physical addressing 4-26
4.2.3 Addressing the inputs and outputs 4-29
Example of address assignment
of outputs 4-31
Example of address assignment
of inputs 4-32
4.2.4 Process data entry via the
CMD software 4-33
4.2.5 Status bits 4-36
4.2.6 Other instructions 4-38
Preprocessing 4-38
Periphery faults (PF) 4-38
Commissioning tips 4-40
VIFB6 - 03/05 4. Commissioning
4-2
9809c