1 Safety and requirements for product use
Festo – P.BE-CPX-CMAX-SYS-EN – en 2017-09b – English 11
Note
Damage to the product from incorrect handling.
Switch off the supply voltage before mounting and installation work. Switch on sup
ply voltage only when mounting and installation work are completely finished.
Never unplug or plug in the product and components attached to the axis connec
tion when powered!
Observe the handling specifications for electrostatically sensitive devices.
1.1.2 Intended use
The Axis controller CPX-CMAX is intended to serve as a position controller for location and force control
of pneumatic drives. Operation is permitted only in combination with:
– an appropriate CPX bus node or control block ( è Section 1.2.5)
– components approved for this purpose on the axis string (è Chapter 3)
The product is intended for use in industrial environments. Outside of industrial environments, e.g. in
commercial and mixed-residential areas, actions to suppress interference may have to be taken. The
Axis controller CPX-CMAX is intended exclusively for use in CPX terminals from Festo for installation in
machines or automated systems.
Use exclusively:
– in perfect technical condition
– In original condition, without unauthorised modifications
– within the limits of the product defined by the technical data (è Appendix A.1)
– in an industrial environment
Note
In the event of damage caused by unauthorised manipulation or other than intended
use, the guarantee is invalidated and the manufacturer is not liable for damages.
To Next Page
Loading...
