Axis controller CPX-CMAX
Festo – P.BE-CPX-CMAX-SYS-EN – en 2017-09b – English 7
Target group
This documentation is intended exclusively for technicians trained in control and automation techno
logy, who have experience in installation, commissioning, programming and diagnostics of positioning
systems.
Versions
This documentation refers to the following versions:
– Axis controller CPX-CMAX with firmware V 2.3 and above.
Note
Before using a newer firmware version, check whether a newer version of the FCT
plug-in or user documentation is available for it
(è www.festo.com/sp, search term CPX-CMAX-C1-1).
Additional information on the version statuses è Help on the FCT-plug-in CMAX.
Service
Consult your regional Festo contact if you have any technical problems.
To Next Page
Loading...
