1 Safety and requirements for product use
12 Festo – P.BE-CPX-CMAX-SYS-EN – en 2017-09b – English
1.2 Requirements for product use
Make this documentation available to the design engineer, installer and person responsible for
commissioning of the machine or system in which this product will be used.
Always comply with the specifications of the documentation. Also consider the documentation for
the other components and modules.
Take into consideration the legal regulations applicable for the location as well as:
– regulations and standards
– regulations of testing organisations and insurers
– national specifications
1.2.1 Transport and storage conditions
Protect the product during transport and storage from excessive stress factors, such as:
– mechanical loads
– impermissible temperatures
– moisture
– aggressive atmospheres
Store and transport the product in its original packaging. The original packaging offers sufficient
protection from typical stresses.
1.2.2 Technical prerequisites
General conditions for the correct and safe use of the product, which must be observed at all times:
Comply with the connection and ambient conditions of the product and all connected components
specified in the technical data. Technical data of the product è Appendix A.1. The product can only
be operated in compliance with the relevant safety regulations if you comply with the limit values
and load limits.
Observe the notes and warnings in this documentation.
1.2.3 Qualification of the specialists (requirements for the personnel)
The product may only be placed in operation by a qualified electrotechnician who is familiar with:
– Installation and operation of electrical control systems
– the applicable regulations for operating safety-engineered systems
– the applicable regulations for accident prevention and occupational safety and
– the documentation for the product
1.2.4 Range of application and certifications
Test values, which the product must comply with and fulfil è Technical data in appendix A.1. Product-
relevant EC directives è Declaration of conformity.
For certificates and the declaration of conformity for this product è www.festo.com/sp.
To Next Page
Loading...
