Festo MPS - Training Contents Overview

1. Introduction
62
© Festo Didactic 655633
Training contents covering the following subjects can be taught:
• Mechanics
– Mechanical construction of a station
• Pneumatics
– Pneumatic grippers
– Pneumatic linear and rotary drives
• Electrical
– Correct wiring of electrical components
• Sensors
– Correct use of limit switches
• PLC
– Programming and use of a PLC
– Actuation of a handling device
• Commissioning
– Commissioning of a production system
• Fault finding
– Systematic fault finding of a production system
Topics for project work
• Selecting pneumatic components
– Parallel grippers
• Application of electric drives
– Linear axis with electric drive
• Safety during pneumatic power failure
– Compressed air reservoir
• Optimising cycle time
1.1
Training contents