Festo MPS - General Notes on Safety

© Festo Didactic 655633 67
General
• Trainees must only work on the station under the supervision of an instructor.
• Observe the data in the data sheets for the individual components, in particular
all notes on safety!
Electrics
• Electrical connections are to be wired up or disconnected only when power is
disconnected!
• Use only low voltages of up to 24 V DC.
Pneumatics
• Do not exceed the permissible pressure of 8 bar (800 kPa).
• Do not switch on compressed until you have established and secured all tubing
connections.
• Do not disconnect air lines under pressure.
• Particular care is to be taken when switching on the compressed air. Cylinders
may advance or retract as soon as the compressed air is switched on.
• Do not exceed the maximum operating pressure
of the Handling station of 4 bar (400 kPa).
Mechanics
• Securely mount all components on the plate.
• No manual intervention unless the machine is at rest.
2. Notes on safety