MS6-SV-...-E-10V24
44 Festo – MS6-SV-...-E-10V24 – 1310b English
2 Requirements for product use
• Make these operating instructions available to the design engineer and installer of the machine or
system in which this product will be used.
• Keep t hese operating instruc tions during the entire product life cycle.
• Take into c onsideration the legal regulations applicable for the destination as well as:
– regulations and standards,
– regulations of the testing organizations and insurers,
– national specifications.
2.1 Technical requirements
General conditions fo r the correct and sa fe use of th e product, which must be observed at all times:
• Maintain the specified limits (e.g. fo r pressures, temperatures and electric voltages).
• Make sure there is a supply of correctly prepared compressed air in accordance with the specifica-
tions on the medium.
• Before mounting, remove particles in the supply lines through appropriate measures. In this way,
you protect the product from premature failure and higher wear.
• Pressurize your entire system slowly. This allows avoidance of abrupt movements.
• Observe the warnings and instructions in these operating instructions.
• Use the product in its original status with the related multi-pin plug socket NECA -... without unau-
thorised modifications.
2.2 Qualification of trained personnel
Installation, mounting, c ommissioning, maintenance, repair and removal from operation may only be
performed by qualified personnel with knowledge and experience with electrical and pneumatic control
technology.
To Next Page
Loading...
