FT-50 Fill Level Inspector Operation Guide
2-4 Industrial Dynamics Company, Ltd. Document 40272-0700
Container Changeover
The FT-50 is equipped will certain features that allow you to change
between different container types easily. If the production line the FT-50
is installed on is designed to produce more than one size or type of
container, this procedure will explain how to reconfigure the unit for a
different container type.
To accomplish a container changeover you must do the following:
• Select the container type to be inspected.
• Adjust the inspection head height.
• Adjust the conveyor guide rails.
• Adjust the centerline trigger bracket height
• Adjust as need any option sensors and senor brackets installed.
Selecting the Container Type to be Inspected
Before you can select a particular container type, the parameters for that
container type must be programmed into the FT-50. This should have
been done by your Service Department.
1.
Press Key 5 until
Current Container Type
appears.
2.
Use the Arrow Key to select the desired container type. After you
select the container type a message will appear asking you to wait
while the FT-50 reconfigures itself for the new container type.
To Next Page
Loading...
