Chapter 3: Using the System Software
Industrial Dynamics Company, Ltd. Document 40272-0700 3-11
System Functions Group
Current Container Type
The container type that is currently being inspected. This function allows
you to select a stored configuration for a particular container type. If your
production line is set up for more than one container type, this function
allows you to switch to different container production without having to
reconfigure the software function parameters.
This function is only available if the unit is configured for multiple
container types. For more information see “Chapter 2: Operating Your
FT-50 ."
To select the Current Container Type:
1.
Press
Key 5
until
Current Container Type
appears.
2.
Press the
Arrow Key
until the desired container type appears.
Last Reject Detected
The type of failure that caused the most recent reject container. The
failure classification can be any of the inspection capabilities installed and
active on your system.
Beacon Status
Determines the operational status of the warning beacon. There are three
status choices:
•
On:
the beacon will flash once for each rejected container and contin-
uously when a diagnostic error occurs. The beacon will stop flashing
when the diagnostic error is cleared.
•
Off:
The beacon will flash once for each rejected container.
•
High Priority Only:
The beacon will flash once for each rejected
container and continuously when a high priority diagnostic error
occurs. The beacon will stop flashing when the diagnostic error is
cleared.
To Next Page
Loading...
