FT-50 Fill Level Inspector Operation Guide
4-6 Industrial Dynamics Company, Ltd. Document 40272-0700
Error Number 33
This error occurs when the number of consecutively rejected smashed
containers exceeds the limit set in the Consecutive smashed bottle reject
alarm function. Report this error to your Service Department.
Error Number 34
Two or more consecutive inspection triggers have occurred with no
smashed bottle sensor transition. Report this error to your Service
Department.
Error Number 46
The number of containers in the consecutive external reject alarm was
exceeded. This is a high priority error condition and will cause the
warning beacon to flash if beacon status is set to high priority only. If this
error persists, report this error to your Service Department.
Error Number 47
Report this error to your Service Department.
Error Number 48
The AC input voltage dropped below 90 volts on a 110 VAC system or
below 185 volts on a 220 VAC system. During the time the voltage was
low, no containers were inspected. When the power returns to normal, the
system resets with no data being lost.
This is a high priority error condition and will cause the warning beacon
to flash if beacon status is set to high priority only. If this error persists,
report this error to your Service Department.
Error Number 49
The user defaults loaded for one or more settings are out of range. Check
all settings to be sure they are correct. This is a high priority error
condition and will cause the warning beacon to flash if beacon status is set
to high priority only. Report this error to your Service Department.
Error Number 50
The System defaults loaded for one or more settings are out of range. A
complete software setup must be performed. This is a high priority error
condition and will cause the warning beacon to flash if beacon status is set
to high priority only. Report this error to your Service Department.
To Next Page
Loading...
