FT-50 Fill Level Inspector Operation Guide
4-8 Industrial Dynamics Company, Ltd. Document 40272-0700
Error Number 67
The number of containers in the consecutive diameter missing cap reject
alarm was exceeded. This is a high priority error condition and will cause
the warning beacon to flash if beacon status is set to high priority only. If
this error persists, report this error to your Service Department.
Error Number 68
No encoder pulses were received for the diameter missing cap width
function. This error condition is low priority and will not cause the
warning beacon to flash during high priority only operation. If this error
persists, report this error to your Service Department.
Error Number 72
This error condition indicates the line speed is to high. The encoder may
need to be calibrated or the gamma sample cutoff limit may be set too
high. This error can also be caused by noise on the encoder cable which
connects to TB4-2. If this error persists, report this error to your Service
Department.
Error Number 86
This error condition indicates the BBU RAM battery is low. Report this
error to your Service Department.
Error Number 117
This error condition indicates there is a host or modbus serial interface
framing error or reply timeout (timeout must be a minimum of 15
seconds.) If this error persists, report this error to your Service
Department.
Error Number 118
This error indicates a host or Modbus serial RX overrun error. The baud
rate may be set incorrectly. If this error persists, report this error to your
Service Department.
Error Number 119
This error indicates a host or Modbus serial parity error occurred. If this
error persists, report this error to your Service Department.
To Next Page
Loading...
