Filtec FT-50 - Adjusting the Centerline Trigger Bracket Height

Chapter 2: Operating Your FT-50
Industrial Dynamics Company, Ltd. Document 40272-0700 2-7
Adjusting the Centerline Trigger Bracket Height
When you adjusted the head height for the new container, the centerline
trigger bracket also moved because it is attached directly to the inspection
head. Therefore, you may need to adjust the trigger bracket to accom-
modate the new container type.
Note
Your Service Department should indicate whether or not you will need to
make this adjustment and what the adjustment should be.
1.
Loosen the centerline trigger bracket height lock. Refer to Figure
2-2-3 on page 2-5 for more information.
2.
There is a height adjustment scale located on the side of the
inspection tunnel that you will use to measure the height (see Figure
2-2-3). Your Service Department may have marked the correct height
for each container type on the scale.
If the correct height is not indicated, or you do not know the correct
height you will need to determine the correct setting:
• For more information see “Aligning the Inspection Trigger
(Bottles)” on page 2-15.
• For more information see “Aligning the Inspection Trigger
(Cans)” on page 2-22.
3.
Use the centerline trigger bracket height adjustment crank to adjust
the bracket height to the proper height.
4.
Tighten the centerline trigger bracket height lock to secure the
position.