Filtec FT-50 - The Rejector Arm Remains Extended; Rejected Container Trajectory Is Sloppy or Inconsistent

Chapter 4: Diagnostics and Troubleshooting
Industrial Dynamics Company, Ltd. Document 40272-0700 4-13
2.
If it is binding, contact your Service Department.
The rejector arm remains extended
1.
Is sufficient oil getting to the rejector? Check the oil level in the oiler
(on some models only).
2.
Turn the FT-50’s power off. If the rejector remains extended, contact
your Service Department.
Rejected container trajectory is sloppy or
inconsistent
1.
Fatigued or worn pads cause the rejected container's trajectory to
change.
2.
Replace rejector pad.