FT-50 Fill Level Inspector Operation Guide
4-10 Industrial Dynamics Company, Ltd. Document 40272-0700
Troubleshooting Procedures
The troubleshooting procedures in this section are designed to help you
quickly correct simple problems with your FT-50. If problems persist, or
if advanced troubleshooting is required, contact your Service Department.
Before you attempt any diagnostic or troubleshooting procedure:
• Read and understand the procedure(s) thoroughly.
• Understand and comply with all safety precautions.
• If you cannot correct the problem, contact your service department.
Is the power turned on
Verify that both the main power switch on the I/O junction box and
the internal power switch located on the power filter junction box are
turned on.
Is the power filter circuit breaker tripped
The internal power switch is an integrated switch/circuit breaker.
When the breaker is tripped, the power switch turns off. If you are
certain power is reaching the FT-50, however the unit will not power
up, contact your Service Department.
Is the Safety Shutter Opened
Check to be sure the safety shutter is opened. An Error 13 usually
indicates the safety shutter is closed. For more information see
“Chapter 2: Operating Your FT-50.”
• If your FT-50 is equipped with the autoshutter, the red signal
beacon will be on indicating the shutter is open.
• If you FT-50 is equipped with a manual safety shutter, check to be
sure the shutter is opened.
The display does not respond when keys are pressed
1.
Turn the FT-50’s main power switch off.
2.
Press and hold the reset button while turning the main power switch
back on. Wait for the three beeps before releasing the reset button.
3.
Inspect the control panel display touchpad for water damage. If
moisture is present, contact your Service Department.
To Next Page
Loading...
