Chapter 3: Using the System Software
Industrial Dynamics Company, Ltd. Document 40272-0700 3-3
Software Function Groups
The Function Group Keys are numbered one through six, representing
each of the following function groups:
• Fill Level Function Group (Key 1)
• Finishing Function Group (Key 2)
• Counters Function Group (Key 3)
• Rejector Function Group (Key 4)
• System Function Group (Key 5)
• Diagnostic Function Group (Key 6)
Operator’s access to the FT-50’s system software grants you rights to
specific functions required to operate the unit, therefore you will have
limited access to each function group.
The Function Keys
Pressing a function key displays the first available function in that group.
Repeatedly pressing the same function key scrolls through the list of
available functions.
The Arrow Keys
The arrow keys allow you to change a parameter value, enable/disable a
function, reset shift counters, or clear an error.
After you select the proper function with a function key, press the Up
Arrow to increase a value or press the Down Arrow to decrease a value.
Holding the key down will rapidly increase the value. After you make a
change, press another function key, or wait 5 seconds, and the value is
automatically entered into memory.
To Next Page
Loading...
