FT-50 Fill Level Inspector Operation Guide
2-18 Industrial Dynamics Company, Ltd. Document 40272-0700
4.
Find your type of missing lid sensor in the table below and adjust the
upper jam nut to raise or lower the sensor to the proper height.
5.
When you achieve the proper height, tighten the lower jam nut to
secure the sensor positioning.
6.
If you closed the manual safety shutter, open it before resuming
operation. For more information see “The Safety Shutter” on
page 2-3.
Description (Lid Type) Maximum Height Above Lid
Nonferrous (Aluminum) 0.4 inch (10 mm)
Photo-Optic Sensor (All) 0.7 inch (18 mm)
Extended Range (Aluminum)
Extended Range (Steel)
0.5 inch (13 mm)
0.88 inch (22 mm)
Standard 0.25-0.38 inch (6-9 mm)
To Next Page
Loading...
