Chapter 2: Operating Your FT-50
Industrial Dynamics Company, Ltd. Document 40272-0700 2-23
3.
Center a properly filled and sealed production container in the
inspection tunnel so that when the sensor mounting bracket is
lowered, it is aligned with the trigger beam.
4.
Lower the bracket until the trigger beam contacts the container at the
widest part of the lid, or if the container is oriented upside down so
the beam contacts the container as shown in Figure 2-2-11.
5.
Tighten the height locking handle to secure the trigger beam
positioning.
6.
If you closed the manual safety shutter, open it before resuming
operation. For more information see “The Safety Shutter” on
page 2-3.
To Next Page
Loading...
