134 MS-9200UDLS/E/C Manual — P/N 52750:F 7/26/2010
Programming Master Programming Level
To select the type, press 1 while viewing the Primary Phone Line screen. The following screen will
be displayed:
Press 1 to select Touchtone dialing, 2 to select Rotary dialing with a make/break ratio of 67/33 or 3
to select Rotary dialing with a make/break ratio of 62/38.
Secondary Phone
Press 3 while viewing On Board DACT Screen #1 to program the type of secondary phone line\
being connected to the DACT. The following screen will be displayed:
To select the type, press 1 while viewing the Secondary Phone Line screen. The following screen
will be displayed:
Press 1 to select Touchtone dialing, 2 to select Rotary dialing with a make/break ratio of 67/33, or 3
to select Rotary dialing with a make/break ratio of 62/38.
Service Terminal
The FACP can be programmed remotely from a PC using a modem and telephone line.
Information can also be retrieved from the FACP using the same method. The Upload/Download
option allows an operator to set the necessary parameters to allow the uploading and downloading
of data between the FACP and PC. The Service Terminal selection provides the means for entering
these parameters.
PHONE LINE
1=TOUCHTONE
2=ROTARY 67/33
3=ROTARY 62/38
Primary Phone Type Screen
ON BOARD DACT
1=ENABLED
2=PRIMARY PHONE
3=SECONDARY PHONE
On Board DACT Screen #1
ON BOARD DACT
SECONDARY PHONE LINE
1=TYPE TOUCHTONE
Secondary Phone Line Screen
PHONE LINE
1=TOUCHTONE
2=ROTARY 67/33
3=ROTARY 62/38
Secondary Phone Type Screen
ON BOARD DACT
1=SERVICE TERMINAL
2=CENTRAL STATION
3=SUPERV PHONE LINE
On Board DACT Screen #2
To Next Page
Loading...
