200 MS-9200UDLS/E/C Manual — P/N 52750:F 7/26/2010
Appendix B: Default Programming
The following table provides a list of the programming options and their factory default settings.
Program Option Factory Default Program Option Factory Default
Detector Programming Not Installed Relay 1 Alarm
Detector Type Smoke-Photo Relay 2 Trouble (fixed)
Detector Verification Off Relay 3 Supervisory
Detector Walktest Yes Annunciator Terminal Mode No
Detector PAS No Annunciator ACS Mode No
Detector Presignal No UDACT No
Detector Zone Assign. 000 only ACS Installed No
Detector Adj/Noun none Onboard DACT No
Module Programming Not Installed Printer-PC No
Module Type Monitor Printer Baud 9600
Module Walktest Yes Service Terminal Panel ID 0000
(not used) Ring Count 0
Module Presignal No Primary Phone Type Touchtone
Module Zone Assign. 000 only Secondary Phone Type Touchtone
Module Adj/Noun none DACT Communication OFF
Zone 0 Enable Enabled AC Loss Delay 2
Zone 1 Enable Enabled Backup Reporting First Available
Zone 2 Enable Enabled Primary Reporting Style Report Point
Zone 3 Enable Enabled Secondary Reporting Style Report Point
.........................through.......... ..................... Primary Account Code 0000
Zone 96 Enable Enabled Secondary Account Code 0000
Zones 97, 98 & 99 Enabled Primary 24 Hour Test Time 0100
(future) Secondary 24 Hour Test Time 0200
Loop Style Style 4 Primary Phone Number
Loop Protocol LITESPEED Secondary Phone Number
Trouble Reminder Off Primary DACT Format Ademco Contact ID
Banner Secondary DACT Format Ademco Contact ID
Time Format 12 Hr ANN-Primary Enabled No
Hours Setting 12 ANN-Primary Modules Addr. 1 - 8 None
Minutes Setting 00 ANN-Secondary Enabled No
Second Settings ANN-Secondary Modules Addr. 1 - 8 None
AM-PM Setting AM ANN-S/PG Port
Month Setting 01 ANN-S/PG Baud 9600
Day Setting 01 ANN-S/PG Data Bits 7
Year Setting 00 ANN-S/PG Parity Even
Daylight Savings Enabled ANN-S/PG Stop Bits 1
Month Start Daylight Savings March ANN-S/PG Offline Timer 60
Week Start Daylight Savings Week 2 ANN-S/PG Printer Supervision No
Month End Daylight Savings November ANN-80 Piezo Enabled Yes
Week End Daylight Savings Week 1 ANN-80 Lock Enabled Yes
Verification OFF ANN-80 Acknowledge Button Enabled Yes
PAS Timer 0 ANN-80 Silence Button Enabled Yes
Presignal Timer 0 ANN-80 Reset Button Enabled Yes
Waterflow Retard Timer 0 ANN-80 Drill Button Enabled Yes
NAC 1, 2, 3 & 4 Enable Enabled ANN-I/O Point/Zone Zone
NAC 1, 2, 3 & 4 Silenceable Yes ANN-I/O Range 00-29
NAC 1, 2, 3 & 4 Type Bell ANN-I/O Active LEDs Only
NAC 1, 2, 3 & 4 Sync Type System Sensor ANN-RLY Relay 1 Zone 1
NAC 1, 2, 3 & 4 Autosilence 0 ................through....................... ............
NAC 1, 2, 3 & 4 Coding Steady ANN-RLY Relay 10 Zone 10
NAC 1, 2, 3 & 4 Zones Zone 000 only ANN-LED Point/Zone Zone
NAC 1, 2, 3 & 4 Silence Inhibit No ANN-LED Alarms/ATS (Alarm, Trbl, Supv) ATS
Canadian Option Enabled No ANN-LED Range 0 - 9
To Next Page
Loading...
