EasyManua.ls Logo

Fischer Panda 10000i - Disposal of the Components

Fischer Panda 10000i
218 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation
Seite/Page 188 - Kaptitel/Chapter 12: Installation 16.1.15
WARNING: Electric voltage DANGER TO LIFE! - Improper operation can result in
health impairment and death.
Electric voltages of more than 48 V are potentially lethal in
any situation. The rules of the respective regional authority
must be adhered to during installation. For safety reasons,
only an electrician may carry out the installation of the
electrical connections of the generator.
WARNING: Hot surface/materialGenerator and cooling water may be hot during and after
operation. Burn/scalding hazard!
During operation, overpressure may build up in the cooling
system.
MANDATORY INSTRUCTION: Protective
equipment required
For installation work, personal protective equipment is
compulsory. This includes:
• Tightly fitting protective clothing
• Safety shoes
• Safety gloves
• Hearing protection
• Safety goggles if applicable
WARNING: Switch off all loads.All loads must be disconnected prior to working on the
generator to avoid damage to the devices.
12.2 Disposal of the components
MANDATORY INSTRUCTION: Protect the
environment.
Electronics components are hazardous to the
environment and contain rare raw materials.
Collect and properly dispose of components that are no
longer needed!
The iControl2 board is typically pre-installed on the generator, and the corresponding connecting lines for connecting
it to the iControl2 panel and the PMGi are prepared. See generator manual.

Table of Contents