FISNAR DC100 MAX - Page 23

DC100 MAX Digital Dispenser Operating Manual
© 2023 Fisnar - 23 - DC100 MAX Rev 4
When the dispense time reaches zero (0) seconds, the machine will
automatically stop dispensing and the dispense time will reset back to the set
dispense time.
The dispense cycle can be stopped before the dispense time reaches zero
(0) by pressing the button.
If the “Dispense Cancel” function has been enabled, t
he dispense cycle can
also be stopped before the dispense time reaches zero (0) by pressing the
foot pedal or the button.
3.
When needed, press the
button to add the time set in the “Add Time+”
function to the dispense time value. The
button can continue to be
pressed to further increase the dispense time cumulatively based upon the
time set in the “Add Time+” function setting.
Press and hold the
button to reset the adjusted dispense time back to
the original set dispense time value in TIMED mode.
4.
To reset the dispense time back to the original set dispense time val
ue in
TIMED mode, press and hold the button.
The dispense time value displayed
under TIME+ mode will not affect the
values in other modes (i.e. TIMED, TEACH, CYCLE). However, changing the
time value in other modes will also change the value in TIME+ mode.