DC100 MAX Digital Dispenser Operating Manual
© 2023 Fisnar - 5 - DC100 MAX Rev 4
Do not operate the machine in excess of its maximum ratings / settings.
Make sure that the input air supply is clean and dry. A 5 micron air filter/regulator
(560567) is recommended to ensure the input air supply is clean and dry.
If corrosive or flammable fluids are being used, a syringe barrel adapter head
assembly with inline filter must be used, to help prevent the fluids from being
sucked back into the machine.
The fluid being dispensed may be toxic and / or hazardous. Refer to the Material
Safety Data Sheet for proper handling and safety precautions.
Do not smoke or use near an open flame when flammable materials are being
dispensed.
Do not expose the machine directly to sunlight.
Avoid cleaning the machine with aggressive solvents – neutral detergents are
preferred.
Do not overfill the barrel and/or lay the barrel on its side. This will prevent fluids
from flowing back into the machine – refer to figures A & B below.
If the machine malfunctions, shut down the machine immediately. This can be
done by either pressing the power button on the front of the machine or
disconnecting the power cord.
Always use a piston with the barrel to prevent fluids from flowing back into the
machine
When dispensing low viscosity fluids that require the vacuum be aware not to
increase to a point where fluids begin to run back into the air line potentially
reaching the control box. The vacuum should not be set too high or it will cause
material to creep backwards.
SAFETY
General Precautions
To Next Page
Loading...