FlexGain PLEX - Page 56

User’s manual FlexGain Plex, V2
Version 1.3 56 from 99
PCM1 remote digital loopback:ON
PCM2 remote digital loopback:OFF
PCM3 remote digital loopback:OFF
PLEX2_01_FMM>RDL PCM1
PCM1 remote digital loopback:ON
PLEX2_01_FMM>
<SETLINE> command.
This command allows the user to perform fine tuning of the V.35 interface by forced
configuration of some of its lines into active, passive or normal state, which can be
controlled by the interface.
The forced configuration of the line is used to connect different data transmission
equipment, which required certain state of interface lines, for example for test purposes,
etc.
Command syntax:
<SETLINE> <DSR|CTS|TST|DCD|FOLLOW> <ON|OFF>
where
ON sets the line into the active state;
OFF sets the line into the passive state;
FOLLOW sets the line into the state controlled by the transceiver, which depends on
the received RTS and DTR signals (ON means to activate, OFF means to deactivate).
To display the help information, enter <SETLINE /H>
Example:
PLEX2_01_FMM>SETLINE DCD ON
V35 acknowledgement lines state:
DSR:1
CTS:1
TST:0
DCD:1
V35 acknowledgement control method: FOLLOW OFF
PLEX2_01_FMM>
<STATUS> command.
The <STATUS> command displays the current status of the device interfaces. This
command is used without any parameters.
To display the help information, enter <STATUS /H>
Example: